Skip to content
CollegeRoute

Mechanical and Manufacturing Engineering points 2025

Dublin City University, course code DC195, level 8.

Its highest figure in the years held here is 542, which is where it closed in 2025.

2025 round one

542

Work out your points and this page will show where your total sits against this course.

Year by year

Round one is the figure most people mean by the points. Round two is what was left after the first offers went out, so it is usually lower and it is not a cut off for the year.

Mechanical and Manufacturing Engineering at Dublin City University, CAO points by year, round one and round two.
YearRound oneRound twoNotes
2020425
2021500
2022511
2023509
2024522
2025542

A dash means no figure was published for that year, usually because the course did not run. Figures are read from the CAO’s published points charts.

Entry requirements

Points are only half of an offer. The subject requirements for this course are set by Dublin City Universityand are not published in the CAO’s points charts, so they are not on this page and nothing here should be read as saying you qualify. Check them on the institution’s own course page, and on cao.ie, before you put this on your form.

Every course at Dublin City University

Close to this

Other places teaching Mechanical and Manufacturing Engineering, then more at Dublin City University.

Where to go next